What changes if you own a BMW, Mini or Supra
On the latest ECUs for these platforms, unlocking was the slowest step of a remap, because it could mean shipping the ECU away. With the EcuTek Bench Programmer, full unlocking of ECUs built after June 2020 is done on the bench with ProECU, and programming can start immediately afterwards with ProECU or PhoneFlash. For the owner that means fewer steps and less time with the car off the road.
ECUs and engines covered
- Bosch MEVD17.2.G: BMW N55 and S55
- Bosch MG1CS003: BMW B58 Gen1
- Bosch MG1CS024: BMW B58 Gen2, BMW S58 and Toyota Supra
- Bosch MG1CS201: Mini B48
For the B58 Gen1 and Gen2, S58, Supra and Mini B48, unlocking applies to ECUs both before and after June 2020.
How the job is done
The ECU is removed from the car and connected to the Bench Programmer with the cable made for that connector; unlocking is run from ProECU and the calibration is loaded straight after. Working on the bench, with the ECU isolated from the car, gives a dedicated connection for that ECU type that does not depend on the car's wiring.
EcuTek does not charge for unlocking. The connector cable and mains plug are specific to each ECU and are not included with the programmer.
What you need to know about your car
The deciding detail is the ECU fitted: MEVD17.2.G, MG1CS003, MG1CS024 or MG1CS201. The ECU code and the build date tell you straight away whether the car is covered and which cable is needed.
ACME's view
Easier unlocking removes a logistical constraint, but the quality of the result still lies in the calibration and how it is validated. ACME is an EcuTek partner and develops calibrations on its hub dyno, where every change is measured rather than estimated.
If the car already has a map from someone else, ACME also supports calibrations from other tuners, on site or remotely.
